Humminbird 531871-1_A Manuel d'utilisateur télécharger pdf

Unit Switch

531871-1_A

Thank You

Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by

esigning and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories

offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.

Your Humminbird® is designed for trouble-free use in even the harshest marine environment. In the unlikely event that

your Humminbird® does require repairs, we offer an exclusive Service Policy - free of charge during the first year after

purchase, and available at a reasonable rate after the one-year period. For complete details, see the Warranty section

included in this manual.

Contact our Customer Resource Center at 1-800-633-1468 or visit our Web site at humminbird.com.

Installation Overview

Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read

these instructions carefully in order to get the full benefit from your Humminbird® accessory. If you find that any items

are missing from your installation kit, call our Customer Resource Center at 1-800-633-1468 or visit our Web site at

humminbird.com.

The Unit Switch comes with all the necessary hardware to allow you to connect your two control heads to one

transducer. The switch is intended for installation on the console, and will work well on almost any boat.

NOTE: The Unit Switch will not allow the six beam-3D transducer to be shared.

Supplies: In addition to the hardware supplied with your Unit Switch, you will need a hand drill with various size bits,

a Phillips screwdriver, an adjustable wrench, and a 3 amp fuse.

700 SERIES™ NOTE: If you are installing the Speed Sensor accessory (optional), you will also need to purchase the

Sonar/Speed Y-Cable. Contact our Customer Resource Center for details at 1-800-633-1468 or visit our Web site at

humminbird.com.

Installation

Before installing the Unit Switch, gather all the parts you will need, and make sure that the planned location of the

Unit Switch will allow you to connect the two control heads to your transducer. Perform the procedures in the

following sections to install the Unit Switch on your boat.

1. Locating the Unit Switch Mounting Position

There are two ways to find the mounting location, as follows:

Switch Panel: If your console already contains a switch panel with an available slot, slide the Unit Switch into the

slot until it snaps into place. Then skip ahead to procedure two.

In-Dash: If your console does not have a switch panel or a pre-made mounting location, you will need to create

one yourself.

Mounting the Switch

Boat Console

Switch

Unit Switch

1 2 3 4

Résumé du contenu

Page 1 - Unit Switch

Unit Switch1531871-1_AThank YouThank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation bydesig

Page 2

To manually create a mounting location:1. Locate a suitable, flat area of the dash to mount the Unit Switch. The switch requires a depth of at least 1

Page 3 - 3. Connecting the Power Cable

To connect the connector clips to the Unit Switch:1. From underneath the console, plug the two connector clips from the switch assembly into the two o

Page 4 - 5. Powering Off

Commentaires sur ces manuels

Pas de commentaire

Humminbird 531871-1_A Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non Humminbird 531871-1_A. Humminbird 531871-1_A User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Humminbird 531871-1_A