Humminbird TCR ID-10 Manuel d'utilisateur télécharger pdf (Page 6)

Step 4

TRANSDUCER ASSEMBLY- Insert the transducer assembly into the metal bracket from the

bottom. Push up until the holes in the plastic pivot align with the uppermost holes in the bracket.

Slide the O-ring on to the headed pin and insert it through the two parts. Assemble by screwing

the ¼”x3/8” allen head screw into the end of the pin and tighten. (See Figure G)

Step 5

ANGLE ALLIGHMENT- Set the transducer angle so that it is parallel with the bottom of the boat

hull. Once proper alignment is achieved, tighten the two allen head screws using the 5/32” allen

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Pas de commentaire

Humminbird TCR ID-10 Manuel d'utilisateur Page 6