Humminbird TCR ID-10 Manuel d'utilisateur télécharger pdf (Page 4)

Once the location is determined mark and drill three 7/64” dia.. holes noted on the template.

Attach the metal bracket using three #10 self threading screws supplied. Be sure to align holes in

the center of the

Bracket slots. On some aluminum boats it may be necessary to use a wood back-up plate. It is

important to use a silicone sealant between the screwhead and bracket in order to prevent

leaking. (See Figure C)

Step 2.

BRACKET INSTALLATION (Fiberglass Boats)- If your boat has a stepped transom located

below and under the main transom, the compact transducer design allows mounting in this area.

This mounting location is recommended for good reading at very high speeds. (See Figure D)

To install the metal bracket on a fiberglass boat, locate the template on the transom in the same

manner as for an aluminum boat. (See Figure C)

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Humminbird TCR ID-10 Manuel d'utilisateur Page 4