Humminbird PIRANHAMAX 190CPT Manuel d'utilisateur Page 35

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 34
Troubleshooting
Do not attempt to repair the PiranhaMAX™ yourself. There are no user-serviceable
parts inside, and special tools and techniques are required for assembly to ensure
the waterproof integrity of the housing. Repairs should be performed only by
authorized Humminbir technicians.
Many requests for repair received by Humminbird® involve units that do not
actually need repair. These units are returned “no problem found. If you have a
problem with your PiranhaMAX™, use the following troubleshooting guide before
calling the Customer Resource Center or sending your unit in for repair.
1. Nothing happens when I turn the unit on.
Check the power cable connection at both ends. Be sure the cable is connected
correctly to a reliable power source red lead to positive, black lead to
negative or ground. Ensure the power available is between 10 and 20 VDC.
Check the power connection to the PiranhaMAX™. It is possible to force the
power cable connector into the cable holder incorrectly. If the connector is
reversed, the unit will not work. Examine the contacts on the back of the unit
to ensure there is no corrosion.
2. There is no transducer detected.
The PiranhaMAX™ has the ability to detect and identify that a transducer is
connected. When powering on, if a message indicates “transducer not
connected”, make sure that an appropriate transducer connector is plugged
into the unit. In addition, inspect the transducer cable from end toend forbreaks,
kinks, or cuts in the outer casing of thecable.Also make sure that the transducer
is fully submerged in water. If the transducer is connected to the unit through
a switch, temporarilyconnect it directly tothe unitand try again.If noneof these
actions identifies an obvious problem, the transducer itself is probably at fault.
Be sure to include the transducer if returning the unit for repair.
29
Vue de la page 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Commentaires sur ces manuels

Pas de commentaire